【国外标准】 Standard Specification for Magnetic Particle Examination of Continuous Grain Flow Crankshaft Forgings

This test method covers the procedures for the standard practice of performing magnetic particle examination of continuous grain flow crankshaft forgings intended for medium speed diesel engines. Crankshafts shall be divided into four zones of decreasing operational stress, each of which have been designated its own set of acceptance criteria. Zone 1, which consists of the major critical areas, includes the crankpin journals, main bearing journals, and oil holes. Zone 2, which consists of the minor critical areas, includes the balance of the fillet radii of the crankpin and main bearing journals not included in Zone 1. Zone 3, which comprises the journal running surfaces, includes the remainder of the crankpin and main bearing journal surfaces not covered by Zones 1 and 2. Finally, Zone 4 comprises all other remaining areas, including the crankpin web surfaces, and flange faces and periphery. Dimpling technique may be used to remove unwanted visual or magnetic particle indications.1.1 This specification covers the magnetic particle examination of forged continuous grain flow (CGF) crankshafts intended for medium speed diesel engines.1.2 For the purpose of magnetic particle indication assessment, the crankshaft is divided into four zones of decreasing operational stress. Acceptance criteria have been set for each zone.1.3 The engines to which these crankshafts are fitted are commonly used for diesel electric locomotives, marine propulsion, and power generation. Engines fueled by natural gas also fall into this medium speed category.1.4 Specification A983/A983M is a product specification that covers the manufacture of CGF crankshafts.1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.