【国外标准】 Standard Practice for Determining the Number of Constrictions “m” of Non-Woven Geotextiles

5.1 This practice provides a calculation method for determining the number of constrictions m of a non-woven geotextile (or of a layer of a composite material). This standard is not applicable to woven geotextiles, knitted geotextiles, heat-bonded geotextiles, or any other type of geosynthetic.5.2 The number of constrictions represents the number of “windows” delimited by three or more fibers, in which soil particles could migrate. This value has been found to be relevant to explain the different filtration behaviors of non-woven geotextiles with similar opening sizes but different structures for various soil conditions (see Appendix X1 for details).5.3 This value will be used in filtration research to evaluate the prediction of filtration efficiency and effectiveness of various non-woven geotextiles with similar opening sizes (Test Method D6767).5.4 Interpretation of the significance of m as calculated using this standard shall be done with care, as some non-woven structures may not reflect the hypothesis used to establish the proposed equation (see Appendix X1 for details).1.1 This practice describes the procedure used along with existing test methods to determine the number of constrictions m of mechanically bonded non-woven geotextiles, based on thickness, mass per unit area, and fiber properties1.2 The number of constrictions is a property of non-woven geotextiles, which is complementary to opening size to predict their filtration behavior. It can be used to differentiate non-woven geotextiles with similar opening sizes but different structures (thickness, weight, fiber diameter, etc.). However, more research is needed to assess its significance when comparing two products with different opening sizes.1.3 Consideration of the number of constrictions is relevant in filtration applications where piping or clogging concerns are to be controlled with a high level of confidence, that is, for filter applications in critical soils.1.4 This standard is for design purposes only and is not intended for quality control purposes.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.