【国外标准】 Standard Specification for Pressure Vessel Plates, Alloy Steel, Molybdenum

This specification covers molybdenum alloy steel plates, intended particularly for welded boilers and other pressure vessels. Plates under this specification are available in three grades having different strength levels: Grade A; Grade B; and Grade C. The steel shall be killed. The steel shall conform to the chemical requirements specified. Tension tests on plates shall conform to the requirements specified.1.1 This specification2 covers molybdenum-alloy steel plates, intended particularly for welded boilers and other pressure vessels.1.2 Plates under this specification are available in three grades having different strength levels as follows:Grade Tensile Strength, ksi [MPa]A 65–85 [450–585]B 70–90 [485–620]C 75–95 [515–655]1.3 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements.1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.