【国外标准】 Standard Specification for Aluminum Jacketing for Insulation

This specification covers aluminum jacketing for thermal and acoustical insulation operating at either above or below ambient temperatures and in both indoor and outdoor locations. It provides physical requirements for aluminum jacketing for thermal and acoustical insulation. Classification of aluminum jacketing is based on three factors: outer surface treatment and emittance, alloy and temper per Specification B209, and moisture retarder. The specification covers physical properties, minimum thickness for pipe jacketing, and permissible thickness tolerances. Test methods cover total hemispherical emittance, surface burning characteristics, metal sheet thickness, pinholes in moisture retarder, pencil hardness, and water vapor transmission rate of the moisture retarder.1.1 This specification covers aluminum jacketing for thermal and acoustical insulation operating at either above or below ambient temperatures and in both indoor and outdoor locations. It does not cover insulation jacketing made from other materials such as mastics, fiber reinforced plastic, PVC, or stainless steel nor does it cover the details of thermal or acoustical insulation systems.1.2 This specification provides physical requirements for aluminum jacketing for thermal and acoustical insulation. Guide C1423 provides guidance in selecting jacketing materials and their safe use.1.3 This is a material specification and does not imply any performance of the installed system using the materials specified herein. For information about installation of aluminum jacketing, see (1).21.4 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.NOTE 1: A version of this specification in SI units is available as Specification C1729M.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.