【国外标准】 Standard Specification for Docking/Drain Plug and Boss Assemblies [Metric] (Withdrawn 2013)

This specification provides design, construction, and purchasing criteria for docking/drain plug and boss assemblies. Assemblies are intended for installation in shell, rudder, and tank bottom plate. Assemblies shall be installed at the lowest point of a tank or rudder for draining during dry docking. Docking plugs and bosses shall be classified as follows: type I - docking plug and bosses for plating from 8 to 15 mm, and type II - docking plug and bosses for plating greater than 15 to 38 mm. The procedure for installing docking/drain plug and boss assemblies are presented. 1.1 This specification provides design, construction, and purchasing criteria for docking/drain plug and boss assemblies. 1.2 Assemblies are intended for installation in shell, rudder, and tank bottom plate from 8 through 38 mm. 1.3 Assemblies shall be installed at the lowest point of a tank or rudder for draining during dry docking. 1.4 The values stated in SI units are to be regarded as the standard.